Technical data

594 Agilent N8201A Performance Downconverter Synthetic Instrument Module, 250 kHz to 26.5 GHz
28 Programming Fundamentals
Programming Command Compatibility Across Modes
Command Subsystem
When you select different modes you get different sets of available programming
commands. That is, only the commands that are appropriate for the current mode are
available. Also, some commands have the same syntax in different modes but have
different ranges or settings that are only appropriate to the current mode.
The following table shows which command subsystems are the same across different
modes. If there is no “X” by a particular subsystem, then the set of available commands is
different in those modes. Command ranges or defaults may also be different. Refer to the
programming command descriptions in the documentation for each mode for details.
Command Subsystem Same command set is available in
Basic mode.
Same command set is available:
SA mode compared with the
application modes: Phase Noise,
Noise Figure, TD-SCDMA
IEEE common commands X X
ABORt X X
CALCulate
CALibration X X
CONFigure
COUPle not available in these application modes not available in these application
modes
DISPlay
FETCh
FORMat X
HCOPy X X
INITiate
INPut not available in these application modes X
MEASure
MEMory X X
MMEMory X X
MMEMory:STORe:TRACe not available in these application modes X
READ