Technical data

558 Agilent N8201A Performance Downconverter Synthetic Instrument Module, 250 kHz to 26.5 GHz
27 Using the STATus System
Recall
*RCL <register>
Recalls the instrument state from the specified instrument memory register.
If the state being loaded has a newer firmware revision than the revision of the instrument,
no state is recalled and an error is reported.
If the state being loaded has an equal firmware revision than the revision of the instrument,
the state will be loaded.
If the state being loaded has an older firmware revision than the revision of the instrument,
the instrument will only load the parts of the state that apply to the older revision.
Key Type: There is no equivalent front-panel key.
Range: Registers are an integer, 0 to 127
Remarks: See also commands :MMEMory:LOAD:STATe and
:MMEMory:STORe:STATe.
Example: *RCL 12
Front Panel Access: File, Recall State
Reset
*RST
Presets the instrument to a factory defined condition that is appropriate for remote
programming operation. In Spectrum Analysis Mode *RST is equivalent to performing
the commands:
• :SYSTem:PRESet, with preset type set to MODE.
• *CLS which clears the STATus bits and error queue.
*RST does not change the mode and only resets the parameters for the current mode.
The :SYSTem:PRESet command is equivalent to the front panel
Preset key.
Save
*SAV <register>
Saves the instrument state to the specified instrument memory register.
Key Type: There is no equivalent front-panel key.
Range: Registers are an integer, 0 to 127