Technical data

Mode Setup (Spectrum Analysis Mode) 17
Agilent N8201A Performance Downconverter Synthetic Instrument Module, 250 kHz to 26.5 GHz 425
Enable All Measurements
Enable All Measurements allows you to access measurements that are disabled. Not all
measurements are available for a particular radio standard. When you select a radio
standard, the keys are grayed out for the measurements that are not available. These
disabled measurements do not have default settings for the standard that you have
selected. So you have to configure the settings yourself when you use them. See also the
Retain Params key function.
If you set
Enable All Measurements to Yes and you enter one of the measurements that
was disabled, then the
Enable All Measurements function will not be available (grayed
out). You cannot turn it off until you enter a measurement that is valid for your selected
standard.
Key Path: Mode Setup
Factory Preset: No
Remote Command:
[:SENSe]:RADio:STANdard:EAMeas YES|NO
[:SENSe]:RADio:STANdard:EAMeas?
Example:
RAD:STAN:EAM YES