Technical data

418 Agilent N8201A Performance Downconverter Synthetic Instrument Module, 250 kHz to 26.5 GHz
17 Mode Setup (Spectrum Analysis Mode)
Remote Command:
Use[:SENSe]:RADio:STANdard[:SELect] See “Radio Std” on page 412.
Example:
RAD:STAN FCC15
WLAN
Accesses the WLAN radio standards key menu to enable you to select a WLAN
standard. Selecting a radio standard modifies spectrum analyzer settings for the SEM
measurement activated under the
MEASURE menu.
802.11a
Sets the specific parameters for the selected measurement (located under the “Measure
(Spectrum Analysis Mode)" on page 233 key description) appropriate for industry standard
802.11a. This standard is only available for the Spectrum Emission Mask (SEM)
measurement.
Key Type: 1 of N menu
Key Path: Mode Setup, Radio Std, W-LAN
Remote Command: Use[:SENSe]:RADio:STANdard[:SELect] See “Radio
Std” on page 412.
Example: RAD:STAN WL802DOT11A
802.11b
Sets the specific parameters for the selected measurement (located under the “Measure
(Spectrum Analysis Mode)" on page 233 key description) appropriate for industry standard
802.11b. This standard is only available for the Spectrum Emission Mask (SEM)
measurement.
Key Type: 1 of N menu
Key Path: Mode Setup, Radio Std, W-LAN
Remote Command: Use[:SENSe]:RADio:STANdard[:SELect] See “Radio
Std” on page 412.
Example: RAD:STAN WL802DOT11B