Technical data

416 Agilent N8201A Performance Downconverter Synthetic Instrument Module, 250 kHz to 26.5 GHz
17 Mode Setup (Spectrum Analysis Mode)
NADC
Sets the specific parameters for the selected measurement (located under the “Measure
(Spectrum Analysis Mode)" on page 233 key description) appropriate for industry standard
NADC. Channel Power and Intermod TOI measurements are not available when
Device
(MS)
is selected. All other measurements are available when this radio standard is selected
except: Spectrum Emissions Mask, Harmonic Distortion, Spurious Emissions, and
Multi-Carrier Power.
Key Type: 1 of N menu
Key Path: Mode Setup, Radio Std
Remote Command:
Use[:SENSe]:RADio:STANdard[:SELect] See “Radio Std” on page 412.
Example:
RAD:STAN NADC
PDC
Sets the specific parameters for the selected measurement (located under the “Measure
(Spectrum Analysis Mode)" on page 233 key description) appropriate for industry standard
PDC. The Burst Power measurement is not available when
Device (BTS) is selected. The
Channel Power and Intermod TOI measurements are not available when
Device (MS) is
selected. All other measurements except Multi-Carrier Power, Harmonic Distortion,
Spurious Emissions and Spectrum Emission Mask measurements are available for this
standard.
Key Type: 1 of N menu
Key Path: Mode Setup, Radio Std
Remote Command:
Use[:SENSe]:RADio:STANdard[:SELect] See “Radio Std” on page 412.
Example:
RAD:STAN PDC