Technical data

412 Agilent N8201A Performance Downconverter Synthetic Instrument Module, 250 kHz to 26.5 GHz

17 Mode Setup (Spectrum Analysis Mode)

Radio Std

Accesses the available radio standard. Selecting a radio standard modifies spectrum

analyzer settings for the measurements activated under the

MEASURE menu.

Measurements that are not relevant to the selected radio standard are not available (grayed

out) and they do not have instrument default settings associated with them. If

Enable All

Measurements

is set to Yes when the Radio Std is pressed, only the standards that are

relevant to the currently active measurement will be available. Unavailable standards will

be grayed out.

Key Path: Mode Setup

Factory Preset: None

Remote Command:

[:SENSe]:RADio:STANdard[:SELect]

NONE|IS95a|JSTD|IS95C|GSM|W3GPP

|C2000MC1|C2000DS|C2000MC3|NADC|PDC|BLUEtooth|TETRa|WL802D

OT11A

None

Selects no radio standard. If Radio Std, None is selected when a measurement is running,

all measurement parameters are returned to their default values. Analyzer parameters

outside the

MEASURE or Meas Setup key menus are not affected.

Key Type: 1 of N menu

Key Path: Mode Setup, Radio Std

Remote Command:

Use[:SENSe]:RADio:STANdard[:SELect] See “Radio Std” on page 412.

Example:

RAD:STAN NONE

IS-95A

Sets the specific parameters for the selected measurement (located under the “Measure

(Spectrum Analysis Mode)" on page 233 key description) appropriate for industry standard

IS-95A. The Spectrum Emissions Mask, Harmonic Distortion, and Spurious Emissions

measurements are not available when this radio standard is selected.