Technical data

Measurement Setup 15
Agilent N8201A Performance Downconverter Synthetic Instrument Module, 250 kHz to 26.5 GHz 397
Factory Preset: Dependent upon Radio Standard and device selected, refer to the default
tables for “Offset/Limits" on page 388 for this value.
Default Terminator: dBc
Range: –200 dBc to 50 dBc
Remote Command:
[:SENSe]:SEMask:OFFSet[n]:LIST:STOP:RCARrier
<real number>,[<real number>]...
[:SENSe]:SEMask:OFFSet[n]:LIST:STOP:RCARrier?
[:SENSe]:SEMask:OFFSet[n]:LIST:STOP:RCARrier:COUPle
OFF|ON|0|1
[:SENSe]:SEMask:OFFSet[n]:LIST:STOP:RCARrier:COUPle?
Remote Command Notes: Comma separated list. When offset F is off, this will be 5
values. When offset F is on, this will be 6 values. n = 1 for BTS and n = 2 for MS. Default is
BTS.
Example:
SEM:OFFS:LIST:STOP:RCAR –20 dBm
SEM:OFFS:LIST:STOP:RCAR
SEM:OFFS:LIST:STOP:RCAR:COUP 0
SEM:OFFS:LIST:STOP:RCAR:COUP?
Fail Mask
Displays the menu to select one of the following logic keys for fail conditions between the
measurement results and the test limits: Absolute, Relative, Abs AND Rel, and Abs OR Rel.
• Absolute - Fail is shown if one of the absolute spectrum emission mask measurement
results is larger than the limit between Abs Start and Abs Stop, inclusive. This is the
default selection for each offset for BTS measurements.
• Relative - Fail is shown if one of the relative spectrum emission mask measurement
results is larger than the limit between Rel Start and Rel Stop, inclusive.
• Abs AND Rel - Fail is shown if one of the absolute spectrum emission mask
measurement results is larger than the limit between Abs Start and Abs Stop, inclusive
AND one of the relative spectrum emission mask measurement results is larger than the
limit for Rel Start and Rel Stop. This is the default for MS measurements.