Technical data

336 Agilent N8201A Performance Downconverter Synthetic Instrument Module, 250 kHz to 26.5 GHz
15 Measurement Setup
ST/Harmonic
Sets the sweep time used to measure each harmonic. The value is set to 200 divided by the
resolution bandwidth, or 10 ms, whichever is greater when the measurement is started.
This sweep time is used only for measuring harmonics. The N8201A sweep time before the
measurement was started is used for finding the fundamental.
Key Path: Meas Setup
State Saved: Saved in Instrument State.
Factory Preset: 10 ms / Auto
Default Terminator: seconds
Range: 10 ms to maximum sweep time of the N8201A.
Remote Command:
[:SENSe]:HARMonics:SWEeptime:STATe OFF|ON|0|1
[:SENSe]:HARMonics:SWEeptime:STATe?
[:SENSe]:HARMonics:SWEeptime <time>
[:SENSe]:HARMonics:SWEeptime?
Remote Command Notes:
ON is equal to automatic (Auto). OFF is equal to manual (Man).
Example:
HARM:SWE:STAT OFF
HARM:SWE 100 ms