Technical data

Measurement Setup 15
Agilent N8201A Performance Downconverter Synthetic Instrument Module, 250 kHz to 26.5 GHz 303
Limit Test
Turns the testing of the limit line on or off. When Limit Test is set to On, each offset is
compared to its upper and lower offset limit. In those cases where the power exceeds the
limit, a red “F” is placed next to the dBc result to indicate a failure. If there are any failures,
the pass/fail indicator area show “FAIL” in red; if there are none, it shows “PASS” in green.
Any offsets that are in the off state (see“Offset Freq" on page 291) are not measured and
their results will not be displayed on screen.
Key Path: Meas Setup
State Saved: Saved in Instrument State.
Factory Preset: Off
Remote Command:
[:SENSe]:ACPower:LIMit[:STATe] OFF|ON|0|1
[:SENSe]:ACPower:LIMit[:STATe]?
Example:
ACP:LIM 1
ACP:LIM?