Technical data

292 Agilent N8201A Performance Downconverter Synthetic Instrument Module, 250 kHz to 26.5 GHz
15 Measurement Setup
Range: 0 Hz to 500 MHz
Remote Command:
[:SENSe]:ACPower:OFFSet:LIST[:FREQuency]
<f_offset>,<f_offset>,<f_offset>,<f_offset>,<f_offset>,
<f_offset>
[:SENSe]:ACPower:OFFSet:LIST[:FREQuency]?
[:SENSe]:ACPower:OFFSet:LIST:STATE
OFF|ON|0|1, OFF|ON|0|1, OFF|ON|0|1, OFF|ON|0|1, OFF|ON|0|1,
OFF|ON|0|1
[:SENSe]:ACPower:OFFSet:LIST:STATE?
Remote Command Notes: This command, along with commands
[:SENSe]:ACPower:OFFSet:LIST:BANDwidth|BWIDth
[:INTegration] and [:SENSe]:ACPower:OFFSet:LIST:STATe, are used
to set the parameters for all of the offsets, up to six. The following table shows the values of
these parameters if no radio standard (None) is selected.
Example:
Sending fewer than six parameters to one of these commands will leave the values of the
unspecified offsets unchanged. If you don’t send settings for all 6 offsets, it will set all the
offsets that you specified, then it will set any remaining offsets to the same setting as the
last offset that you sent.
ACP:OFFS:LIST 50 Hz,75 Hz,100 Hz,125 Hz,150 Hz,175 Hz
ACP:OFFS:LIST:STAT ON,ON,ON,OFF,OFF,OFF
For example, after the above command is sent, sending the command with only four
paramenters (ACP:OFFS:LIST:STAT ON,ON,ON,OFF) will result in the fifth and
sixth offset remaining the same as the previous setting (OFF).
Offset State Frequency Integ. BW
A ON 3 MHz 2 MHz
BOFF0 2 MHz
COFF0 2 MHz
DOFF0 2 MHz
EOFF0 2 MHz
FOFF0 2 MHz