Technical data

1
Agilent N8211A/N8212A Performance Upconverter Synthetic Instrument Module, 250 kHz to 20 / 40 GHz 25
List of Commands
*CAL? “Calibration Query" on page 555
*CLS “Clear Status" on page 555
*ESE, *ESE? “Standard Event Status Enable" on page 555
*ESR? “Standard Event Status Register Query" on page 556
*IDN? “Identification Query" on page 556
*LRN? “Instrument State Query" on page 556
*OPC, *OPC? “Operation Complete" on page 556
*OPT? “Query Instrument Options" on page 557
*PSC, *PSC? “Power-On Status Clear" on page 557
*RCL “Recall" on page 558
*RST “Reset" on page 558
*SAV “Save" on page 558
*SRE, *SRE? “Service Request Enable" on page 559
*STB? “Read Status Byte Query" on page 559
*TRG “Trigger" on page 559
*TST? “Self Test Query" on page 560
*WAI “Wait-to-Continue" on page 560
ABORt “Abort the Sweep or Measurement (Remote Command Only)" on page 232
:CALCulate:LLINe:ALL:DELete “Delete All Limits" on page 136
:CALCulate:LLINe:CMODe FIXed|RELative “Limits (Fixed Rel)" on page 135
:CALCulate:LLINe:CMODe? “Limits (Fixed Rel)" on page 135
:CALCulate:LLINe:CONTrol:DOMain FREQuency|TIME “X Axis Units" on page 135
:CALCulate:LLINe:CONTrol:DOMain? “X Axis Units" on page 135
:CALCulate:LLINe[1]|2:AMPLitude:INTerpolate:TYPE LOGarithmic|LINear “Amptd Interp" on page 134
:CALCulate:LLINe[1]|2:AMPLitude:INTerpolate:TYPE? “Amptd Interp" on page 134
:CALCulate:LLINe[1]|2:CONTrol:INTerpolate:TYPE LOGarithmic|LINear “Freq Interp" on page 133
:CALCulate:LLINe[1]|2:CONTrol:INTerpolate:TYPE? “Freq Interp" on page 133
:CALCulate:LLINe[1]|2:DATA <x-axis>, <ampl>, <connected>{,<x-axis>,<ampl>,<connected>}
“Limits" on page 126