Technical data

156 Agilent N8201A Performance Downconverter Synthetic Instrument Module, 250 kHz to 26.5 GHz
7 File
Load
Displays the menu key that enables you to load instrument-data files from the selected
drive and directory back into the instrument. This function displays the file list box, which
shows the data-entry fields for the file name, type, destination, and path.
The catalog list box is active and can be used for selecting the file information in the
data-entry fields. Only loadable files that match the current type are shown. Placing the
cursor on a file name causes it to be loaded into the file name field.
Key Path: File
Load Now
Loads the currently selected file. Displayed settings include name, type, destination, and
path. While the file is being loaded a popup message is displayed “Loading file.” After
a successful load, the text message “xxxxxx file loaded” (where xxxxxx is the file
name) appears in the status line. When traces are loaded they always load in
View mode.
Traces save in TRC format can be loaded individually or as a group. When a trace is loaded,
the state that existed when that trace was saved is loaded along with the trace. Also, the
loaded trace(s) is/are placed in view mode.
To compare two saved traces from different saves, place traces in view mode before saving
them. This prevents the trace from being rewritten based on a state change from
subsequent loads.
Key Path: File, Load
Remote Command:
:MMEMory:LOAD:STATe 1,<‘file_name’> loads the specified state file into
the current active state of the instrument.
The MMEM:LOAD:STAT command only saves the state of the Signal Analysis mode. Use
*RCL to load all mode states. *RCL <register#> loads the state from the specified
internal register into the current active state of the instrument. The available register
numbers are 0 to 127.
:MMEMory:LOAD:TRACe <label>,<‘file_name’>
:MMEMory:LOAD:CORRection
ANTenna|CABLe|OTHer|USER,<‘file_name’>
:MMEMory:LOAD:LIMit LLINE1|LLINE2,<‘file_name’>
Remote Command Notes:
For the MMEM:LOAD:TRAC <‘file_name’> command, <‘file_name’> must
include the following: