Technical data

Using the LAN Interface 2
Agilent N8211A/N8212A Performance Upconverter Synthetic Instrument Module, 250 kHz to 20 / 40 GHz 39
Tip: There are two other ways to access the device’s Web page:
• By double-clicking on the Device listing in the Synthetic Instrument Finder.
• By typing in the device’s hostname or IP address in your Internet browser.
Open using Synthetic GUI Opens the Synthetic Instrument GUI.
Copy VISA Address to Clipboard (IP Address) Copies the VISA IP address to the
clipboard for use in other applications.
Copy VISA Address to Clipboard (Hostname) Copies the VISA hostname to the
clipboard for use in other applications. It is recommended that you use this address on
networks with DHCP and DNS network capability.
How to Reset the LAN Configuration
On the instrument front panel, near the power switch, is a recessed button labeled
“RESET”. This button enables you to place the LAN configuration of the instrument into a
known state.
When this button is pressed (a straightened paper clip will do the job) the following settings
are made and the system reboots.
• Subnet Mask is set to 255.255.0.0