Technical data

308 Agilent N8211A/N8212A Performance Upconverter Synthetic Instrument Module, 250 kHz to 20 / 40 GHz
9 Analog Commands
Internal Triggered & Doublet: 70nS to (42 S - 20 nS - pulse width)
:PULM:INTernal[1]:DELay:STEP
Supported Option UNU or UNW
[:SOURce]:PULM:INTernal[1]:DELay:STEP <num><time_suffix>
[:SOURce]:PULM:INTernal[1]:DELay:STEP?
Sets the step increment for the pulse delay.
The step value, set by this command, is used with the UP and DOWN choices in the
“:PULM:INTernal[1]:DELay" on page 307 command.
The step value set with this command is not affected by a N8211A/N8212A power-on,
preset, or *RST command.
Example
:PULM:INT:DEL:STEP 10NS
The example sets the pulse delay step value to 10 nS.
Range 10 nS to –20 nS (pulse period)
:PULM:INTernal[1]:FREQuency
Supported Option UNU or UNW
[:SOURce]:PULM:INTernal[1]:FREQuency <val><units>|UP|DOWN
[:SOURce]:PULM:INTernal[1]:FREQuency?
Sets the pulse rate for the internally-generated square wave using the variable
<val><units>. The command, used with the UP|DOWN parameters, will change the
frequency by a user-defined step value. Refer to the
“:PULM:INTernal[1]:FREQuency:STEP" on page 309 command for setting the value
associated with the UP and DOWN choices.
This command is used when SQUare is the pulse modulation type. Refer to
“:PULM:SOURce" on page 312 for the pulse modulation type selection.
Example
:PULM:INT:FREQ 1MHZ
The example sets the square wave pulse rate to 1 megahertz.
*RST +4.00000000E+002