Technical data

300 Agilent N8211A/N8212A Performance Upconverter Synthetic Instrument Module, 250 kHz to 20 / 40 GHz
9 Analog Commands
[:SOURce]:PM[1]|2:INTernal[1]:FREQuency:ALTernate?
Sets the frequency rate for the alternate signal. The alternate frequency is the second tone
of a dual–sine or the stop frequency of a swept–sine waveform.
Refer to “:PM[1]|2:INTernal[1]:FUNCtion:SHAPe" on page 301 for the waveform selection.
Example
:PM1:INT1:FREQ:ALT 50KHZ
The example sets the alternate frequency rate for the ΦM tone 2, ΦM path 1, source 1 to
50 kHz.
*RST +4.00000000E+002
Range Dual_sine 0.1 Hz - 100 kHz Swept-sine 0.1 Hz - 100 kHz
:PM[1]|2:INTernal[1]|2:FUNCtion:NOISe
Supported Option UNT
[:SOURce]:PM[1]|2:INTernal[1]|2:FUNCtion:NOISe GAUSsian|UNIForm
[:SOURce]:PM[1]|2:INTernal[1]|2:FUNCtion:NOISe?
Selects a gaussian or uniform noise modulation for the selected path(s).
Example
:PM1:INT1:FUNC:NOIS GAUS
The example selects a gaussian noise modulation for ΦM path 1, source 1.
*RST UNIF
:PM[1]|2:INTernal[1]|2:FUNCtion:RAMP
Supported Option UNT
[:SOURce]:PM[1]|2:INTernal[1]|2:FUNCtion:RAMP POSitive|NEGative
[:SOURce]:PM[1]|2:INTernal[1]|2:FUNCtion:RAMP?
Selects a positive or negative slope for the ramp modulating waveform.
Example
:PM1:INT2:FUNC:RAMP POS