Technical data

Analog Commands 9
Agilent N8211A/N8212A Performance Upconverter Synthetic Instrument Module, 250 kHz to 20 / 40 GHz 291
Low Frequency Output Subsystem ([:SOURce]:LFOutput)
:LFOutput:AMPLitude
Supported Option UNT
[:SOURce]:LFOutput:AMPLitude <val><units>
[:SOURce]:LFOutput:AMPLitude?
Sets the amplitude of the signal at the LF OUTPUT connector.
Example
:LFO:AMPL 2.1VP
The example sets the peak amplitude to 2.1 volts.
*RST 0.00
Range 0.000 Vp–3.5 Vp
:LFOutput:FUNCtion[1]|2:FREQuency
Supported Option UNT
[:SOURce]:LFOutput:FUNCtion[1]|2:FREQuency <val><units>
[:SOURce]:LFOutput:FUNCtion[1]|2:FREQuency?
Sets the frequency of function generator 1 or 2. The command sets:
• the frequency of the first tone of a dual–sine waveform
• the start frequency for a swept–sine waveform
• the frequency for all other waveform types
Refer to “:LFOutput:FUNCtion[1]|2:SHAPe" on page 293 for selecting the waveform type.
Example
:LFO:FUNC1:FREQ .1MHZ
The example sets the frequency for function generator 1 to 100 kHz.
*RST +4.00000000E+002
Range Sine and Dual Sine: 0.5 Hz - 1 MHz Swept-Sine: 1 Hz - 1 MHz