Technical data

286 Agilent N8211A/N8212A Performance Upconverter Synthetic Instrument Module, 250 kHz to 20 / 40 GHz
9 Analog Commands
[:SOURce]:FM[1]|2:INTernal[1]:SWEep:RATE?
Sets the sweep rate for the swept–sine waveform. The minimum resolution is 0.5 hertz.
Refer to “:FM[1]|2:INTernal[1]|2:FUNCtion:SHAPe" on page 288 for the waveform
selection.
Example
:FM1:INT:SWE:RATE 20KHZ
The example sets the sweep rate for the swept–sine waveform to 20 kHz.
*RST +4.00000000E+002
Range 0.5 Hz–100 kHz
:FM[1]|2:INTernal[1]:SWEep:TRIGger
Supported Option UNT
[:SOURce]:FM[1]|2:INTernal[1]:SWEep:TRIGger BUS|IMMediate|EXTernal
[:SOURce]:FM[1]|2:INTernal[1]:SWEep:TRIGger?
Sets the trigger source for the FM swept–sine waveform. Refer to
“:FM[1]|2:INTernal[1]|2:FUNCtion:SHAPe" on page 288 for the waveform selection.
BUS Enables LAN triggering using the *TRG command.
IMMediate Enables immediate triggering of the sweep event.
EXTernal Enables the triggering of a sweep event by an externally applied signal at the
TRIGGER IN connector.
*RST IMM
Example
:FM1:INT:SWE:TRIG BUS
The example selects the bus as the trigger source for FM path 1.
:FM[1]|2:INTernal[1]|2:FREQuency
Supported Option UNT
[:SOURce]:FM[1]|2:INTernal[1]|2:FREQuency <val><units>|UP|DOWN
[:SOURce]:FM[1]|2:INTernal[1]|2:FREQuency?