Technical data

Analog Commands 9
Agilent N8211A/N8212A Performance Upconverter Synthetic Instrument Module, 250 kHz to 20 / 40 GHz 285
[:SOURce]:FM[1]|2:INTernal[1]:FREQuency:ALTernate <val><units>
[:SOURce]:FM[1]|2:INTernal[1]:FREQuency:ALTernate?
Sets the internal FM rate of the alternate signal. The alternate signal frequency is the
second tone of a dual–sine or the stop frequency of a swept–sine waveform.
Refer to “:FM[1]|2:INTernal[1]|2:FUNCtion:SHAPe" on page 288 for the waveform
selection.
Example
:FM1:INT:FREQ:ALT 20KHZ
The example sets the FM tone 2 rate for FM path 1, FM source 1, to 20 kHz.
*RST +4.00000000E+002
Range dual–sine: 0.5 Hz–100 kHz swept–sine: 0.5 Hz–100 kHz
:FM[1]|2:INTernal[1]:FREQuency:ALTernate:AMPLitude:PERCent
Supported Option UNT
[:SOURce]:FM[1]|2:INTernal[1]:FREQuency:ALTernate:AMPLitude:
PERCent <val><units>
[:SOURce]:FM[1]|2:INTernal[1]:FREQuency:ALTernate:AMPLitude:PERCent?
Sets the amplitude of the second tone for a dual–sine waveform as a percentage of the total
amplitude. For example, if the second tone makes up 30% of the total amplitude, then the
first tone is 70% of the total amplitude. Refer to
“:FM[1]|2:INTernal[1]|2:FUNCtion:SHAPe" on page 288 for the waveform selection.
Example
:FM1:INT:FREQ:ALT:AMPL:PERC 20
The example sets the amplitude for FM tone 2, FM path 1, FM internal source 1 to 20% of
the total amplitude.
*RST +5.00000000E+001
Range 0–100%
:FM[1]|2:INTernal[1]:SWEep:RATE
Supported Option UNT
[:SOURce]:FM[1]|2:INTernal[1]:SWEep:RATE <val><units>