Technical data

Basic Function Commands 8
Agilent N8211A/N8212A Performance Upconverter Synthetic Instrument Module, 250 kHz to 20 / 40 GHz 245
:LIST:DWELl:TYPE
Supported All
[:SOURce]:LIST:DWELl:TYPE LIST|STEP
[:SOURce]:LIST:DWELl:TYPE?
Toggles the dwell time for the list sweep points between the values defined in the list
sweep and the value for the step sweep.
LIST Selects the dwell times from the list sweep. Refer to “:LIST:DWELl" on page 244 for
setting the list dwell points.
STEP Selects the dwell time from the step sweep. Refer to “:SWEep:DWELl" on page 251
for setting the step dwell.
Example
:LIST:DWEL:TYPE STEP
The example selects the dwell time from step sweep values.
*RST LIST
:LIST:FREQuency
Supported All
[:SOURce]:LIST:FREQuency <val>{,<val>}
[:SOURce]:LIST:FREQuency?
Sets the frequency values for the current list sweep points. The maximum number of points
is 1601. The setting enabled by this command is not affected by a power-on, preset, or *RST
command.
The variable <val> is expressed in hertz.
Example
:LIST:FREQ 10GHZ,12GHZ,14GHZ,16GHZ