Technical data

224 Agilent N8211A/N8212A Performance Upconverter Synthetic Instrument Module, 250 kHz to 20 / 40 GHz

7 System Commands

Unit Subsystem (:UNIT)

:POWer

Supported All

:UNIT:POWer?

Terminates an amplitude value in the selected unit of measure.

If the amplitude reference state is set to on, the query returns units expressed in dB. Setting

any other unit will cause a setting conflict error stating that the amplitude reference state

must be set to off. Refer to,“:REFerence:STATe" on page 267 for more information.

All power values in this chapter are shown with DBM as the unit of measure. If a different

unit of measure is selected, replace DBM with the newly selected unit whenever it is

indicated for the value.

Example

:UNIT:POW DBM

The example selects dBm as the unit of amplitude measurement.

*RST DBM