Technical data

System Commands 7
Agilent N8211A/N8212A Performance Upconverter Synthetic Instrument Module, 250 kHz to 20 / 40 GHz 219
:SYSTem:SECurity:LEVel:STATe ON|OFF|1|0
:SYSTem:SECurity:LEVel:STATe?
Arms and executes the current security level parameter.
On (1) Arms and prevents any changes to the current security level. Refer to
“:SECurity:LEVel" on page 217 for setting the security level.
OFF (0) Performs the actions required for the current security level setting. Cycling the
signal generator power also performs the same function.
Example
:SYST:SEC:LEV:STAT ON
The example arms the secure mode selected with the SYSTem:SECurity:LEVel command.
:SECurity:OVERwrite
Supported All
:SYSTem:SECurity:OVERwrite
Removes all user files, table editor files values, and flatness correction files. The memory is
then overwritten with random data as described below.
SRAM All addressable locations will be overwritten with random characters.
HARD DISK All addressable locations will be overwritten with random characters.
FLASH MEMORY The flash blocks will be erased.
:SECurity:SANitize
Supported All
:SYSTem:SECurity:SANitize
Removes all user files, table editor files values, and flatness correction files. The memory is
then overwritten with a sequence of data as described below.
SRAM All addressable locations will be overwritten with random characters.
NOTE
Ensure that you select the security level prior to executing this command with the ON (1)
selection. Once you enable the state, you cannot reduce the security level.