Technical data

200 Agilent N8211A/N8212A Performance Upconverter Synthetic Instrument Module, 250 kHz to 20 / 40 GHz

7 System Commands

Enables bits in the Data Questionable Calibration Event Enable register. Bits enabled and

set in this register will set the Calibration Summary bit (bit 8) in the Data Questionable

Condition register.

The variable <val> is the sum of the decimal values of the bits that you want to enable.

Refer to the Chapter 4, “Programming the Status Register System for more information on

programming the status registers.

Example

:STAT:QUES:CAL:ENAB 1

This command enables bit 0 (decimal 1, DCFM/DCΦM Zero Failure) in the Data

Questionable Calibration Event Enable register.

Range 0–32767

:QUEStionable:CALibration:NTRansition

Supported All

:STATus:QUEStionable:CALibration:NTRansition <val>

:STATus:QUEStionable:CALibration:NTRansition?

Enables bits in the Data Questionable Calibration Negative Transition Filter register. A

negative transition (1 to 0) of corresponding bits in the Data Questionable Calibration

Condition register will pass through and be read by the Data Questionable Calibration Event

The variable <val> is the sum of the decimal values of the bits that you want to enable.

Refer to the Chapter 4, “Programming the Status Register System for more information on

programming the status registers.

Example

:STAT:OPER:NTR 3

This exampleL enables bit 0 (decimal 1, DCFM/DCΦM Zero Failure) and bit 1 (decimal 2,

I/Q Calibration Failure) in the Data Questionable Calibration Negative Transition Filter

Range 0–32767

:QUEStionable:CALibration:PTRansition

Supported All

:STATus:QUEStionable:CALibration:PTRansition <val>