Technical data

182 Agilent N8211A/N8212A Performance Upconverter Synthetic Instrument Module, 250 kHz to 20 / 40 GHz
7 System Commands
*SRE?
Returns the decimal sum of bits enabled in the Service Request Enable register. Bit 6
(decimal 64) is not available in this register.
Refer to Chapter 4, “Programming the Status Register System for more information on
programming the status registers.
Range 0–63, 128–191
*STB?
Supported All
*STB?
Reads the decimal sum of the bits set in the Status Byte register.
Refer to Chapter 4, “Programming the Status Register System for more information on
programming the status registers.
Range 0–255
*TRG
Supported All
*TRG
Triggers the device if BUS is the selected trigger source, otherwise, *TRG is ignored. Refer
to “:TRIGger[:SEQuence]:SLOPe" on page 222 for more information on triggers.
*TST?
Supported All
*TST?
Initiates the internal self-test and returns one of the following results:
0 all tests passed.
1 one or more tests failed.
This test can take up to 7 minutes to complete. Ensure that your time out state is set
appropriately.