Technical data

180 Agilent N8211A/N8212A Performance Upconverter Synthetic Instrument Module, 250 kHz to 20 / 40 GHz
7 System Commands
Returns the ASCII character 1 in the Standard Event register indicating completion of all
pending operations.
Refer to Chapter 4, “Programming the Status Register System for more information on
programming the status registers.
*PSC
Supported All
*PSC ON|OFF|1|0
Controls the automatic power-on clearing of the Service Request Enable register, the
Standard Event Status Enable register, and the device-specific event enable registers.
Refer to Chapter 4, “Programming the Status Register System for more information on
programming the status registers.
The setting enabled by this command is not affected by a power-on, preset, or *RST
command.
ON (1) Enables the power-on clearing of the listed registers.
OFF (0) Disables the clearing of the listed registers and they retain their status when a
power-on condition occurs.
Example
*PSC ON
*PSC?
Supported All
*PSC?
Returns the flag (1 or 0) setting as enabled by the *PSC command.
*RCL
Supported All
*RCL <reg>,<seq>
Recalls the state from the specified memory register <reg> in the specified sequence
<seq>.
Range registers: 0–99 Sequences: 0–9