Technical data

System Commands 7
Agilent N8211A/N8212A Performance Upconverter Synthetic Instrument Module, 250 kHz to 20 / 40 GHz 179
Refer to Chapter 4, “Programming the Status Register System for more information on
programming the status registers.
*ESR
Supported All
This is a destructive read. The data in the register is latched until it is queried. Once queried,
the data is cleared.
Refer to Chapter 4, “Programming the Status Register System for more information on
programming the status registers.
*ESR?
Returns the decimal sum of the bits set in the Standard Event register.
*IDN?
Supported All
*IDN?
Requests an identification string from the N8211A/N8212A. The IDN string consists of the
following information:
<company_name>, <model_number>, <serial_number>, <firmware_revision>
The identification information can be modified. Refer to “:IDN" on page 212 for more
information.
*OPC
Supported All
*OPC
Sets bit 0 in the Standard Event register.
Refer to Chapter 4, “Programming the Status Register System for more information on
programming the status registers.
*OPC?
Supported All
*OPC?