Manualshelf

User`s guide

ManualsBrandsAgilent Technologies ManualsMultimeterN6705
51525354555657585960
Operating the DC Power Analyzer 3
Model N6705A User’s Guide 59
Scope Properties
With the Scope View displayed, press the Properties key. In the
Display Trace area, select which traces you wish to display. If no box
is checked, no traces will be displayed for that output.
NOTE
Voltage, current, and power traces can be displayed simultaneously on Agilent
N676xA Power Modules. All other power modules can display only voltage or
current traces, but not simultaneously.
Use the Trigger Mode dropdown list to select a trigger mode.
Mode: Description:
Auto
Configures the scope to display a single-sweep measurement either when a
trigger is received, or automatically if a trigger is not received. The scope
continues running and waits for another trigger when the measurement
completes.
Single
Configures the scope to display a single-sweep measurement when a trigger
is received. The scope stops running when the measurement completes.
Triggered
Configures the scope to display a single-sweep measurement when a trigger
is received. The scope continues running and waits for the next trigger when
the measurement completes.
NOTE
When the trigger mode is set to Auto, the scope triggers itself when it runs.
Otherwise, you need to provide a trigger for the scope to make a measurement.
Use the Trigger Source dropdown list to select a trigger source. This
trigger source will trigger all of the scope measurements. Depending
upon the selected trigger source, you can trigger the scope as follows:
Trigger Source: Description:
Voltage <1-4> level
Current <1-4> level
Triggers the measurement when the voltage or current of the
corresponding output passes through the specified level.
Arb Run/Stop key Trigger the measurement when the Arb Run/Stop key is pressed.
Output On/Off key
Trigger the measurement when any of the Output On/Off keys are
pressed. Also applies to the All Outputs On/Off key.
BNC Trigger In
Provide a low-true signal to the BNC trigger input connector. The signal
must have a minimum pulse width of 2 microseconds.
Remote Command Send a trigger command over one of the three interfaces (i.e. *TRG).