User`s guide

3 Operating the DC Power Analyzer
52 Model N6705A User’s Guide
Select the Arb Trigger Source
Specify a Trigger source for the arbitrary waveforms. The same
trigger source will be used to trigger all of the arbitrary waveforms.
Press the Arb key, then select the Trigger Source field.
Trigger Source: Description:
Arb Run/Stop key
BNC Trigger in
Remote Command
The front panel Run/Stop key
The rear trigger input BNC connector
A remote interface command.
Note that the arbitrary waveforms that you have already configured
should appear in the Arb Preview window. The DC Value column
indicates the present output voltage or current setting. This value
appears at the output before the Arb is run. The output will revert to
this value when the Arb completes unless the Last Arb value box has
been checked.
The Repeat column indicates how many times the Arb will be
repeated if it has been configured to repeat. If the column is blank,
the Arb will only run once. The symbol indicates Arb will run
continuously.
Select the Arb Measurement View
There are two ways to view the arbitrary waveforms.
Meter View – Press the Meter View key to view the output voltage
and current values when the Arb is generated. The voltage and
current meters automatically update.
Scope View – Press the Scope View key to view the output voltage
and current waveforms when the Arb is generated. Note that in
Scope View, you must select the type of waveforms you wish to view
for each output. Press the Properties key and select which
waveforms you wish to display in the Display Trace area. You must
also specify the Trigger Source and Trigger Mode. The trigger source
should be the same as the Arb trigger source previously selected. The
trigger mode should be set to Single.