User`s guide

3 Operating the DC Power Analyzer
50 Model N6705A User’s Guide
User-Defined Properties
You can configure either a voltage or a current waveform. The
following window shows the voltage waveform properties.
Parameter: Description:
Step <n>
Voltage
(voltage waveforms only)
Current
(current waveforms only)
Time
Trigger
Add
Delete
Import (.csv format)
Export (.csv format)
Each part of the waveform is defined as a
step consisting of a voltage or current,
dwell time, and trigger option. The total
number of steps determines Arb length.
The voltage value of the step.
The current value of the step.
The time that the output stays at the step.
Generates an external trigger signal at the
start of the step when checked.
Inserts a step below the selected step;
values are copied from the previous step.
Deletes the presently selected step.
Imports a current or voltage Arb list.
Exports a voltage or current Arb list.
TIP
When multiple steps are displayed, use the up and down navigation keys to
scroll through the list.
Converting Data from a Standard Arb to a User-Defined Arb
You can populate the User-Defined voltage or current Arb with values
from a previously configured “standard” arbitrary waveform. This
lets you edit specific points in the standard arbitrary waveform.
To convert one of the standard Arbs, select an Arb and specify the
Arb parameters. Then select the Edit Points button. This populates
the User-Defined Arb with the values from the properties that you
specified in the standard Arb. You either edit the steps directly in the
User-Defined Properties window or export the Arb to a spreadsheet
for editing using the Export function as explained later in this
chapter.