User`s guide

Appendix C SCPI Commands
136 Model N6705A User’s Guide
SCPI Command Description
[SOURce:]
ARB (ARB commands only on N6705A)
:COUNt <NRf+> | INFinity, (@chanlist) Sets the Arb repeat count
:CURRent
:UDEFined
:BOSTep[:DATA] <Bool> {,<Bool>}, (@chanlist) Generate triggers at the Beginning Of STep
:POINts? (@chanlist) Returns the number of BOST points
:DWELl <NRf> {,<NRf>}, (@chanlist) Sets the user-defined dwell values
:POINts? (@chanlist) Returns the number of dwell points
:LEVel <NRf> {,<NRf>}, (@chanlist) Sets the user-defined current values
:POINts? (@chanlist) Returns the number of current points
:FUNCtion STEP | RAMP | STAircase | SINusoid |
PULSe | TRAPezoid | EXPonential |
UDVoltage | UDCurrent | NONE, (@chanlist)
Selects the ARB function
:TERMinate:LAST <Bool>, (@chanlist) Sets the ARB termination mode
:VOLTage
:CONVert (@channel) Converts the selected ARB to a user-defined list
:EXPonential
:END[:LEVel] < NRf+>, (@channel) Sets the end voltage of the exponential ARB
:STARt
[:LEVel] < NRf+>, (@channel) Sets the initial voltage of the exponential ARB
:TIMe < NRf+>, (@channel) Sets the length of the start time or delay
:TCONstant < NRf+>, (@channel) Sets the time constant of the exponential ARB
:TIMe < NRf+>, (@channel) Sets the time of the exponential ARB
:PULSe
:END:TIMe < NRf+>, (@channel) Sets the length of the end time
:STARt
[:LEVel] < NRf+>, (@channel) Sets the initial voltage of the pulse
:TIMe < NRf+>, (@channel) Sets the length of the start time or delay
:TOP
[:LEVel] < NRf+>, (@channel) Sets the top level voltage of the pulse
:TIMe < NRf+>, (@channel) Sets the length of the pulse
:RAMP
:END
[:LEVel] < NRf+>, (@channel) Sets end voltage of the ramp
:TIMe < NRf+>, (@channel) Sets the length of the end time
:RTIMe < NRf+>, (@channel) Sets the rise time of the ramp
:STARt
[:LEVel] < NRf+>, (@channel) Sets the initial voltage of the ramp
:TIMe < NRf+>, (@channel) Sets the length of the start time or delay
:SINusoid
:AMPLitude < NRf+>, (@channel) Sets the amplitude of the sine wave
:FREQuency < NRf+>, (@channel) Sets the frequency of the sine wave
:OFFSet < NRf+>, (@channel) Sets the DC offset of the sine wave
:STAircase
:END
[:LEVel] < NRf+>, (@channel) Sets the end voltage of the staircase
:TIMe < NRf+>, (@channel) Sets the length of the end time
:NSTeps < NRf+>, (@channel) Sets the number of steps in the staircase
:STARt
[:LEVel] < NRf+>, (@channel) Sets the initial voltage of the staircase
:TIMe < NRf+>, (@channel) Sets the length of the start time or delay
:TIMe <NRf+>, (@channel) Sets the length of the staircase