User`s guide

1 Quick Reference
22 Model N6705 User’s Guide
Front Panel Menu Reference
Menu Heading Description
Source Settings ►
Voltage and Current Settings… Configures the voltage and current settings, ranges, and emulation modes.
Protection…
Configures the over-voltage and over-current protection. Enables output coupling so ALL
outputs are disabled when a fault occurs. Also clears output protection.
Advanced Protection… Enables/disables the output inhibit function.
Output On/Off Delays… Configures output on/off delays.
Output On/Off Coupling… Couples specific outputs for the output on/off and delay function.
Output Grouping… Groups identical outputs for output paralleling function.
Advanced… Configures advanced functions including voltage slew rate, sensing, and power limit.
Ratings… Displays power module ratings, serial number, firmware, and option information.
Arb ►
Arb Preview Displays the present status of the arbitrary waveforms that have been configured.
Arb Selection… Selects arbitrary waveforms for each output. Arb Properties configures the selected Arb.
Meter ►
All Outputs Meter View Displays the meter view of all outputs.
Single Output Meter View Displays the meter view of the selected output.
Meter Properties… Configures the meter view voltage and current measurement ranges.
Scope ►
Standard View Displays the standard scope view including vertical, horizontal, and trigger settings.
Marker View Displays the measurement markers and measurement calculations area.
Scope Properties…
Configures the scope traces and voltage and current measurement ranges for individual
outputs. Also configures the trigger source, mode, and horizontal offset.
Marker Properties… Configures the measurements that appear on the bottom of the display in Marker view.
Horizontal Properties… Configures the horizontal offset reference and sample points.
Datalogger ►
Standard View Displays the data log strip chart view including vertical, horizontal, and progress settings.
Marker View Displays the measurement markers and measurement calculations area.
Datalogger Properties… Configures the data log traces and voltage and current measurement ranges for individual
outputs. Also configures the data log duration, sample period, and Min/Max values.
File Name Selection… Specifies the filename for the next data logger acquisition.
Marker Properties… Configures the measurements that appear on the bottom of the display in Marker view.
File ►
Save… Saves an instrument state or a scope measurement.
Load… Loads an instrument state, scope data, or logged data.
Export…
Exports scope data, logged data, or a user-defined arbitrary waveform
Import… Imports s user-defined arbitrary waveform.
Screen Capture… Captures the screen that was active when the File key was pressed.
File Management… Accesses additional file functions: New Folder, Delete, Rename, Copy, File Details.
Reset/Recall/Power-On State…
Resets the instrument to factory defaults; Saves/recalls instrument states; and specifies
the power-on turn on state.