User`s guide

Appendix B SCPI Commands
186 Model N6705 User’s Guide
SCPI Command Description
MEASure[:SCALar] (continued)
:POWer
[:DC]? (@chanlist)
Takes a measurement, returns the average output power
:VOLTage
[:DC]? (@chanlist)
Takes a measurement; returns the average voltage
:ACDC? (@chanlist)
Takes a measurement; returns the total rms voltage (AC + DC)
:HIGH? (@chanlist)
Takes a measurement; returns the high level of a voltage pulse
:LOW? (@chanlist)
Takes a measurement; returns the low level of a voltage pulse
:MAXimum? (@chanlist)
Takes a measurement; returns the maximum voltage
:MINimum? (@chanlist)
Takes a measurement; returns the minimum voltage
:ARRay
:CURRent [:DC]? (@chanlist)
Takes a measurement; returns the instantaneous output current
:POWer [:DC]? (@chanlist)
Takes a measurement; returns the instantaneous output power
:VOLTage [:DC]? (@chanlist)
Takes a measurement; returns the instantaneous output voltage
MMEMory
:ATTRibute? <“object”>, <“attribute”>
Gets the attributes of a file system object
:DATA [:DEFinite]? <“filename”>
Copies file contents; response is a definite length binary block
:DELete <“filename”>
Deletes a file
:EXPort
:DLOG <“filename”>
Exports a data log from the display to a file
:LOAD
:ARB:SEQuence <“filename”>, (@chanlist)
Loads an Arb sequence
:STORe
:ARB:SEQuence <“filename”>, (@chanlist)
Stores an Arb sequence
OUTPut
[:STATe] <Bool> [,NORelay], (@chanlist)
Enables/disables the specified output channel(s)
:COUPle
:CHANNel [<NR1> {,<NR1>}]
Selects which channels are coupled
:DOFFset <NRf>
Specifies a maximum delay offset to synchronize output changes
:MODE AUTO | MANual
Specifies the output delay coupling mode
:MAX
:DOFFset?
Returns the maximum delay offset required for a mainframe
:DELay
:FALL <NRf+>, (@chanlist)
Sets the output turn-off sequence delay
:RISE <NRf+>, (@chanlist)
Sets the output turn-on sequence delay
:PMODe VOLTage | CURRent, (@chanlist)
Sets the mode for turn on/off transitions (N6761A, N6762A)
:TMODe HIGHZ | LOWZ, (@chanlist
Specifies the turn-off output impedance (only on N678xA SMU)
:INHibit
:MODE LATChing | LIVE | OFF
Sets the remote inhibit input
:PON
:STATe RST | RCL0
Programs the power-on state
:PROTection
:CLEar (@chanlist)
Resets latched protection
:COUPle <Bool>
Enables/disables channel coupling for protection faults
:DELay <NRf+>, (@chanlist)
Sets the over-current protection programming delay
:OSCillation[:STATe] <Bool>, (@chanlist)
Enables/disables output oscillation protection (N678xA SMU)
:WDOG
[:STATe] <Bool>
Enables/disables the I/O watchdog timer
:DELay <NRf+>
Sets watchdog timer delay
:RELay
:POLarity NORMal | REVerse, (@chanlist)
Sets the output relay polarity (only on option 760)