User`s guide

Using the Measurement Functions 4
Model N6705 User’s Guide 121
Step 4 – Turn on output 1, start the Arb, and log the data:
Press Data Logger to return the display to the data logger view.
• Press the Output 1 On key to turn on output 1.
• Press the Run/Stop key to run the data logger. When this key is lit,
the data logger is initiated and the output 1 trace is displayed on the
screen.
• Press the Arb Run/Stop key to start the user-defined Arb and
trigger the data logger.
The data logger will run for 30 seconds and log the voltage data from
output 1. When the data log completes, you should see the output
waveform displayed as follows:
A message will indicate that the logged data has been saved in a file
named default.dlog. If you wish to save the data under a different
filename, you must specify the filename before the data logger runs.
Select the Filename button located in the Datalogger Properties
dialog to specify a filename.
Step 5 – Use the marker controls to measure the logged data:
Press Data Logger to display the marker controls.
• Use the marker 1 and Marker 2 knobs to move the markers along
the voltage trace. Measurements between the markers are displayed
on the bottom of the display.
• You can also use the Vertical Volts/Div knob and the Horizontal
Time/Div knob to zoom in on any portion of the logged data.