Technical data

4 Notes on USB Electrical Compliance Testing

In This Book

This manual contains notes on the electrical tests that are performed by

the USB 2.0 compliance test option; it describes the equipment used, and

it describes how the tests are performed.

• Chapter 1, “Installing the USB 2.0 Compliance Test Option” shows how

to install and license the automated test application software (if it was

purchased separately).

• Chapter 2, “Preparing to Take Measurements” describes the equipment

required, how to set up the equipment, how to start the USB 2.0

Compliance Test Option, and how to run tests.

• Chapter 3, “Device Hi- Speed Tests” describes the equipment used for

each test setup.

• Chapter 4, “Hub Hi- Speed Tests” describes the equipment used for each

test setup.

• Chapter 5, “Host Hi- Speed Electrical Tests” describes the equipment

used for each test setup.

• Chapter 6, “Troubleshooting Hi- Speed Test Failures” describes the

Debug Mode options that can be used when troubleshooting hi- speed

test failures.

• Chapter 7, “Low and Full Speed Tests” describes the equipment used

for each test setup.

• Chapter 8, “On- The- Go Electrical Tests” describes the equipment used

for the test setup.