User`s guide

User’s Guide 49
U3025AE10 Operational Check
Figure 46 Calibration, Cal Set Viewer
9. From the Cal Sets drop-down menu, select 999.x (the next sequential number). Select
the Reflection Tracking(1,1) term in the center drop-down menu and ensure that the
Enable and Error Terms are selected as shown in Figure 47.
NOTE You may also create a table on the PNA and enter the limit line stimulus and
response values. Select Limit Test ON and Limit Line ON, and press Show
Table. See Figure 47.
Figure 47 Limit Values for Reflection Tracking Trace (Port 1-12)
Error Terms
Enable