User`s guide

User’s Guide 13
U3025AE10 General Specifications
Access Ports – 2.4 mm (female)
• SOURCE OUT
•
CPLR THRU
• CPLR ARM
• A IN – B IN
Line Switch
– Standby
1 – ON (Active LED On)
Figure 4 Rear Panel (Multiport Test Set)
Control Lines and Voltage Adjust
For further information pertaining to control lines and voltage adjustments see “DUT
Control Lines” on page 38.
Test Set Interface
The Test Set Interface connector is used to send address and data to the test set from the
PNA.
Pass Through Interface
Connection to another test set.
Bias Tee Inputs - Option 001 (only)
BNC female Connectors.
Control Lines Voltage Adjust Option 001 Bias Tee Inputs
Test Set Interface Pass Through Interface
Line
Module