User`s guide
Table Of Contents
- U3042AE12
- Title Page
- TOC
- Introduction
- Description
- Available Options
- Verifying the Shipment
- General Specifications
- Typical Reflection Tracking
- Front and Rear Panel Features
- System Setup with N5230A/C
- Controlling the Test Set with N5230A
- System Setup with N5242A
- Controlling the Test Set with N5242A or N5230C
- DUT Control Lines
- Test Set I/O Interface Commands
- Operational Check
- Troubleshooting Operational Check Failures
- Service Information
- Theory of Operation
- RF Switch Components
- S100 - Source to Ports (1, 5, 9 and 13)
- S200 - Source to Ports (2, 6, 10 and 14)
- S300 - Source to Ports (3, 7, 11 and 15)
- S400 - Source to Ports (4, 8, 12 and 16)
- S101 - Receiver to Ports (1, 5, 9 and 13)
- S201 - Receiver to Ports (2, 6, 10 and 14)
- S301 - Receiver to Ports (3, 7, 11 and 15)
- S401 - Receiver to Ports (4, 8, 12 and 16)
- RF Coupler Components
- System Block Diagram
- Safety and Regulatory Information
- Electrostatic Discharge Protection
- Contacting Agilent
User’s Guide 87
U3042AE12 Theory of Operation
Figure 69 U3042AE12 Option 002 Configuration
Port 13
SOURCE
CPLR THUR
CPLR ARM
RCVR A OUT
SOURCE
CPLR THRU
CPLR ARM
RCVR C OUT
SOURCE
CPLR THRU
CPLR ARM
SOURCE
CPLR THRU
CPLR ARM
Module 1 Module 2 Module 3
Module 4
C
1
234
C
1
2
3
4
PNA P2
JUMPERS
PNA P3
JUMPERS
PNA P4
JUMPERS
SW 100
SW 101
SW 300
SW 301
SW 400
SW 401
SW 200
SW 201
PNA P1
JUMPERS
U3042AE12 option 002
Note: All amplifiers have attenuators on
outputs, not shown in block diagram.
Port 9 Port 5 Port 14 Port 10 Port 6 Port 15 Port 11 Port 7
RCVR D OUT
Port 16 Port 12 Port 8
RCVR B OUT