Specifications

Regulatory Information
General Specifications
Chapter 3 43
Cleaning
Use a soft, clean, damp cloth to clean the front-panel and side covers.
Usage
This Test Set is designed for indoor use only.
WARNING Appliance coupler (mains input power cord) is the power disconnect device. Do
not position the Test Set such that access to the coupler is impaired.
WARNING For continued protection against fire hazard, replace the line fuse only with the
same type and line rating (250V, T 3.15A, 20mm Time-Lag fuse with Low
breaking capacity, Agilent Part Number 2110-0638).
The use of other fuses or materials is prohibited. Always disconnect the Test Set
from the mains supply before attempting to replace the fuse.
WARNING No operator serviceable parts inside. Refer servicing to qualified personnel. To
prevent electrical shock do not remove covers.
WARNING If this Test Set is not used as specified, the protection provided by the
equipment could be impaired. This Test Set must be used in a normal condition
only (in which all means for protection are intact).
CAUTION This Test Set is designed for use in Installation Category II and Pollution Degree 2
per IEC61010 and 60664 respectively.
N4010-90086.book Page 43 Friday, April 4, 2014 3:12 PM