Specifications

v
flammable gasses or fumes.
DO NOT perform procedures involving cover or shield removal unless you are
qualified to do so: Operating personnel must not remove equipment covers or
shields. Procedures involving the removal of covers and shields are for use by
service-trained personnel only.
DO NOT service or adjust alone: Under certain conditions, dangerous voltages may
exist even with the equipment switched off. To avoid dangerous electrical shock,
service personnel must not attempt internal service or adjustment unless another
person, capable of rendering first aid and resuscitation, is present.
DO NOT operate damaged equipment: Whenever it is possible that the safety
protection features built into this product have been impaired, either through
physical damage, excessive moisture, or any other reason, REMOVE POWER and
do not use the product until safe operation can be verified by service-trained
personnel. If necessary, return the product to a Agilent Sales and Service Office for
service and repair to ensure the safety features are maintained.
DO NOT substitute parts or modify equipment: Because of the danger of
introducing additional hazards, do not install substitute parts or perform any
unauthorized modification to the product. Return the product to an Agilent Sales and
Service Office for service and repair to ensure the safety features are maintained.
CAUTION Before switching on this Test Set, make sure that the correct fuse is installed and
ensure the power supply voltage is in the specified range.
CAUTION Mains supply voltage fluctuations should not exceed +/- 10% of the nominal
selected line voltage.
N4010-90086.book Page v Friday, April 4, 2014 3:12 PM