Specifications

v
DO NOT operate the product in an explosive atmosphere or in the
presence of flammable gasses or fumes.
DO NOT perform procedures involving cover or shield removal unless
you are qualified to do so: Operating personnel must not remove
equipment covers or shields. Procedures involving the removal of
covers and shields are for use by service- trained personnel only.
DO NOT service or adjust alone: Under certain conditions, dangerous
voltages may exist even with the equipment switched off. To avoid
dangerous electrical shock, service personnel must not attempt internal
service or adjustment unless another person, capable of rendering first
aid and resuscitation, is present.
DO NOT operate damaged equipment: Whenever it is possible that the
safety protection features built into this product have been impaired,
either through physical damage, excessive moisture, or any other
reason, REMOVE POWER and do not use the product until safe
operation can be verified by service- trained personnel. If necessary,
return the product to a Agilent Sales and Service Office for service
and repair to ensure the safety features are maintained.
DO NOT substitute parts or modify equipment: Because of the danger
of introducing additional hazards, do not install substitute parts or
perform any unauthorized modification to the product. Return the
product to an Agilent Sales and Service Office for service and repair
to ensure the safety features are maintained.
CAUTION Before switching on this Test Set, make sure that the correct fuse is
installed and ensure the power supply voltage si in the specified range.
CAUTION Mains supply voltage fluctuations should not exceed +/- 10% of the
nominal selected line voltage.