Specifications

Making Your First Measurements
Connecting USB, GPIB or LAN
Chapter 234
Connecting by LAN
The Test Set has two LAN operating modes.
• Dynamic Host Configuration Protocol (DHCP)
• Static IP (Manual Mode)
Configuring the Test Set
The IP Address, Subnet Mask, and Default Gateway, can be changed
manually or remotely.
The IP address, Subnet Mask, and Default Gateway values are stored
in non- volatile memory and are not part of the save- recall function.
DHCP LAN Connection.
In DHCP mode the IP Address, Subnet Mask, and Default Gateway
values are obtained automatically from the server. Using DHCP does
not require a detailed knowledge of your network configuration. Refer
to “DHCP Mode” on page 35 for further information.
Static IP LAN Connection.
In static mode you must set up the IP Address, Subnet Mask, and
Default Gateway to be compatible with your network infrastructure. To
use Static IP you need to obtain these values from your network
administrator. Refer to “Static IP” on page 38 for further information.
NOTE USB is recommended for a direct connection between your computer
and the Test Set. Refer to “Connecting by USB” on page 31.