Specifications

Making Your First Measurements
Running a Confidence Check on the Front Panel (Bluetooth)
Chapter 2 15
Running a Confidence Check on the Front Panel
(Bluetooth)
To operate Bluetooth testing from the Front Panel, your N4010A must
be configured with:
• Option 101.
Refer to the N4010A web page at www.agilent.com/find/N4010A for
firmware updates.
To verify your configuration, press the
System key, an example is
shown in Figure 2-1.
Figure 2- 1 Typical System Configuration Screen
To run a confidence check you also require a Bluetooth device, for
example, a Bluetooth enabled mobile phone.
1. Make the Equipment Under Test (EUT) discoverable. Refer to
manufacturer’s handbook for instructions.
2. Fix an antenna to the RF IN/OUT or connect EUT directly to the
connector. Shown in Figure 2-2.
Figure 2- 2 Test Set RFIO Connections
3. Press the
Config key.