User`s guide

79
Agilent InfiniiVision 2000 X-Series Oscilloscopes
User's Guide

6
Digital Channels
To connect the digital probes to the device under test 79
Acquiring waveforms using the digital channels 83
To display digital channels using AutoScale 83
Interpreting the digital waveform display 84
To switch all digital channels on or off 86
To switch groups of channels on or off 86
To switch a single channel on or off 86
To change the displayed size of the digital channels 85
To reposition a digital channel 87
To change the logic threshold for digital channels 86
To display digital channels as a bus 88
Digital channel signal fidelity: Probe impedance and grounding 91
To replace digital probe leads 96
This chapter describes how to use the digital channels of a Mixed- Signal
Oscilloscope (MSO).
The digital channels are enabled on MSOX2000 X- Series models and
DSOX2000 X-Series models that have the DSOX2MSO upgrade license
installed.
To connect the digital probes to the device under test
1 If necessary, turn off the power supply to the device under test.