User`s guide

238 Agilent InfiniiVision 2000 X-Series Oscilloscopes User's Guide
18 Utility Settings
1 Write the following information on a tag and attach it to the
oscilloscope.
• Name and address of owner.
• Model number.
• Serial number.
• Description of service required or failure indication.
2 Remove accessories from the oscilloscope.
Only return accessories to Agilent Technologies if they are associated
with the failure symptoms.
3 Package the oscilloscope.
You can use the original shipping container, or provide your own
materials sufficient to protect the instrument during shipping.
4 Seal the shipping container securely, and mark it FRAGILE.
Configuring the [Quick Action] Key
The [Quick Action] key lets you perform common, repetitive actions by
pressing a single key.
To configure the [Quick Action] key:
1 Press [Utility] > Quick Action > Action; then, select the action that should be
performed:
• Off — disables the [Quick Action] key.
• Quick Measure All — displays a popup containing a snapshot of all the
single waveform measurements. The Source softkey lets you select the
waveform source (which also becomes the source selection in the
Measurement Menu). See Chapter 13, “Measurements,” starting on
page 167.
• Quick Print — prints the current screen image. Press Settings to set up
the printing options. See Chapter 17, “Print (Screens),” starting on
page 219.
• Quick Save — saves the current image, waveform data, or setup. Press
Settings to set up the save options. See Chapter 16, “Save/Recall
(Setups, Screens, Data),” starting on page 205.