User`s guide
224 Agilent InfiniiVision 2000 X-Series Oscilloscopes User's Guide
18 Utility Settings
• LAN — When a DSOXLAN LAN/VGA module is installed, you can use
the LAN Settings and LAN Reset softkeys to configure the LAN
interface. See "Setting up the Oscilloscope's LAN Connection" on
page 224.
• GPIB — When a DSOXGPIB GPIB module is installed, you can use the
Address softkey to configure the GPIB address.
• There are no configuration settings for the USB interface.
When an I/O interface is installed, remote control over that interface is
always enabled. Also, the oscilloscope can be controlled via multiple I/O
interfaces (for example, USB and LAN) at the same time.
See Also • Chapter 19, “Web Interface,” starting on page 241 (when the
oscilloscope is connected to a LAN).
• "Remote Programming via the Web Interface" on page 246
• The oscilloscope's Programmer's Guide.
• "Remote Programming with Agilent IO Libraries" on page 247
Setting up the Oscilloscope's LAN Connection
When the DSOXLAN LAN/VGA module is installed, you can place the
oscilloscope on the network and set up its LAN connection. Once that is
done, you can use the oscilloscope's web interface or remotely control the
oscilloscope via the LAN interface.
The oscilloscope supports methods for automated LAN configuration or
manual LAN configuration (see "To establish a LAN connection" on
page 225). It is also possible to set up a point- to- point LAN connection
between a PC and the oscilloscope (see "Stand- alone (Point-to- Point)
Connection to a PC" on page 226).
Once the oscilloscope is set up on the network, you can use the
oscilloscope's web page to view or change its network configuration and
access additional settings (like the network password). See Chapter 19,
“Web Interface,” starting on page 241.
NOTE
When you connect the oscilloscope to a LAN it is a good practice to limit access to the
oscilloscope by setting a password. By default, the oscilloscope is not password protected.
See "Setting a Password" on page 252 to set a password.