- AGILE USER'S MANUAL Printers N-Series

ManualsBrandsAgilent Technologies ManualsPrinterN-Series

Table Of Contents

TABLE OF CONTENTS

Page 4-29XES COMMANDS

This command assigns a number to one of up to ten forms which can then

be recalled for merging into a variable document, where # is the number

(0-9) to be assigned and formname.FRM is the name of the form to which

the number is being assigned. This command is placed anywhere on the

variable page after the Print Job command and before the first Form Merge

Start command.

Form Merge Start

COMMAND:COMMAND:

COMMAND: s

zb#zb#

zb#

RANGE:RANGE:

RANGE:

0-90-9

0-9

This command invokes a form with an assigned identification number for

merging with a text document, where # is the form ID number.

Cycleforms

COMMAND:COMMAND:

COMMAND: s

zxzx

formform

form

,form,form

,form

,…forrm,…forrm

,…forrm

6464

RANGE:RANGE:

RANGE:

1-641-64

1-64

This command enables repeated merging of a set of forms at specified

intervals in a job consisting of multiple variable pages, where form

, form

and form

are the names of the forms as they are stored on disk. The

commas are used not only to separate form names, but can also be used to

indicate any variable pages in which merging is not to occur. This

command is placed after the Print Job command in the first series of

variable pages to be merged.

Form Merge Stop

COMMAND:COMMAND:

COMMAND: s

zh#zh#

zh#

RANGE:RANGE:

RANGE:

0-90-9

0-9

This command stops the merging of a form with a variable page, where #

is the number (0-9) of the form to be stopped.

Page Merge Start

COMMAND:COMMAND:

COMMAND: s

zeze