- AGILE USER'S MANUAL Printers N-Series

Table Of Contents

Page 4-25XES COMMANDS

Line Draw (X or Y)

COMMAND:COMMAND:

COMMAND: s

x(or y)X,Y,L,W,Sx(or y)X,Y,L,W,S

x(or y)X,Y,L,W,Sd

RANGE:RANGE:

RANGE:

See BelowSee Below

See Below

To draw a line parallel to the x (short edge) axis, enter:

sxX,Y,L,W,Sd

To draw a line parallel to the y (long edge) axis, enter:

syX,Y,L,W,Sd

where X and Y specify the starting point of the line, where L is the length

of the line expressed in dots, where W is the width of the line expressed in

dots (with a value between 1 and 31), and where S is the line shading (any

value between 0 and 15 is accepted, where 15 is solid black).

For example, if the user would like to draw a line on a portrait orientation

page, parallel to the y axis, that starts 1.75" over from the x origin and

0.25" up from the y origin, and that is 6.0" long and 1/50" wide:

sy525,75,1800,6d

The page orientation is determined by the first font on the page, so be

certain to specify a font before using this command.

To draw a line on a landscape orientation page, parallel to the x axis, that

starts 5.0" down from the x origin and 1.5" over from the y origin, and that

is 4.0" long and 1/100" wide:

sx1500,150,1200,3d

Document Enhancement Commands

This section describes the commands for bolding, underlining,

overstriking, subscripting and superscripting text.

Bold Start

COMMAND:COMMAND:

COMMAND: s

RANGE:RANGE:

RANGE:

N/AN/A

N/A