- AGILE USER'S MANUAL Printers N-Series

ManualsBrandsAgilent Technologies ManualsPrinterN-Series

Table Of Contents

TABLE OF CONTENTS

User’s ManualPage 4-12

Output Tray

COMMAND:COMMAND:

COMMAND: s

zr#zr#

zr#

RANGE:RANGE:

RANGE:

0-90-9

0-9

This command selects an output tray, where # is a value of 0 (top output

tray) or 1-9 (high capacity stacker).

Offset

COMMAND:COMMAND:

COMMAND: s

RANGE:RANGE:

RANGE:

N/AN/A

N/A

This command tells the printer, if it has offset stacking capability, to offset

the stacking of each document. Offset can be changed on a page-by-page

basis, and is controlled by the last command preceding the form feed.

Duplex Start

COMMAND:COMMAND:

COMMAND: s

zyd#zyd#

zyd#d

RANGE:RANGE:

RANGE:

0-2,5500-2,550

0-2,550

This command enables duplex printing for documents that will be bound

on the side of the page. If a value is entered for #, the left and right

margins on the second side of the page will be shifted to the left by the

amount specified in 1/300" units.

The command must be entered before any printable data on the first page

to be printed duplex. Duplexing is ended with the Duplex Stop command.

The XLi supports this command in both portrait and landscape

orientations. The Shift parameter is not supported, and its use results in

no operation.

Duplex Invert Start

COMMAND:COMMAND:

COMMAND: s

zyfzyf

zyfd

RANGE:RANGE:

RANGE:

0-3,3000-3,300

0-3,300

This command enables duplex printing for documents that will be bound

on the top of the page. If a value is entered for #, the top and bottom