Troubleshooting guide

63
Instrument Operating System
Disk Drive Recovery Process
A window appears showing the extraction
process.
Following the extraction screen, there
may be a short period where there is
no activity on the screen. The desk
top may be displayed for a short
period.
Follow the on-screen prompts to continue
the installation.
WARNING When you see the message Programming FPGAs...Do NOT
turn off power to the instrument, be sure to do as it
says and DO NOT turn off the instrument power at this time
for ANY reason. If this process is interrupted the instrument
most likely will need to be sent back to an Agilent Service
Center for servicing before it will be usable again.
NOTE The installation process can take up to 45 minutes. Do not turn the
instrument power off or serious damage may occur. If any pop up
windows appear, click OK or Ignore to proceed.
When the installation has finished, select
Yes, I want to restart my computer now,
Finish.
After the instrument restarts, the newly
installed version of the X-Series
instrument software will run.
Installing the Software
Step Notes