Troubleshooting guide

23
Quick-Start
Instrument Information
Battery Information
The EMI Receiver uses a lithium battery located on the CPU board. This is not an
operator replaceable part. See “Returning an EMI Receiver for Service” on
page 105. Replaceable parts must be approved or supplied by Agilent Technologies.
You can order the service documentation for the instrument through your Agilent
Sales and Service office.
WARNING Danger of explosion if battery is incorrectly replaced. Replace only with the
same or equivalent type recommended. Discard used batteries according to the
manufacturer’s instructions.
Do not throw batteries away but collect as small chemical waste.
Protecting against electrostatic discharge
Electrostatic discharge (ESD) can damage or destroy electronic components (the
possibility of unseen damage caused by ESD is present whenever components are
transported, stored, or used).
Test equipment and ESD
To help reduce ESD damage that can occur while using test equipment:
WARNING Do not use these first three techniques when working on circuitry with a voltage
potential greater than 500 volts.
• Before connecting any coaxial cable to an EMI Receiver connector for the first
time each day, momentarily short the center and outer conductors of the cable
together.
• Personnel should be grounded with a 1 MΩ resistor-isolated wrist-strap before
touching the center pin of any connector and before removing any assembly from
the instrument.