Troubleshooting guide

Quick-Start

Shortening the Instrument Power-On Time

The instrument desktop includes a shortcut to the ConfigureApplications.exe

application that lets you control your instrument power-on configuration. You can set

the configuration to pre-load only the applications that you typically run. This can

significantly shorten the time it takes for your instrument to power-on. You can also

access this functionality by pressing: System, Power On, Configure Applications.

If (after power-on) you want to access an application that you did not pre-load, it will

take a little longer to bring it up once you press the application softkey. This longer

time-frame is only for the first access after power-on. After the initial access, mode

(application) switching will operate as quickly as if the application was pre-loaded.

Instrument Information

Power requirements

The only physical installation of your EMI Receiver is a connection to a power

source. Line voltage does not need to be selected.

This instrument does not contain customer serviceable fuses.

WARNING This is a Safety Class 1 Product (provided with a protective earthing ground

incorporated in the power cord). The mains plug shall only be inserted in a

socket outlet provided with a protective earth contact. Any interruption of the

protective conductor inside or outside of the product is likely to make the

product dangerous. Intentional interruption is prohibited. (IEC 348 clauses

17.3.3c & 17.3.4)

Failure to ground the instrument properly can result in personal injury. Before

turning on the instrument, you must connect its protective earth terminals to

the protective conductor of the main power cable. Insert the main power cable

plug into a socket outlet that has a protective earth contact only. DO NOT

defeat the earth-grounding protection by using an extension cable, power cable,

or autotransformer without a protective ground conductor.

CAUTION This product is designed for use in Installation Category II and Pollution Degree 2

per IEC 61010 Second Edition and IEC 664 respectively.

This instrument has autoranging line voltage input. Be sure the supply voltage is

within the specified range.

The Mains wiring and connectors shall be compatible with the connector used in the

premise electrical system. Failure, to ensure adequate earth grounding by not using

the correct components may cause product damage, and serious injury.